BOLD MAGENTA part numbers are new for 2025 FUEL/AIR SYSTEMS PARTS-UNLIMITED.COM ATV/UTV | 2025 FUEL/AIR SYSTEMS 1271 DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 4-6 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. DESCRIPTION PART # Speed governor 1020-1226 SPEED GOVERNOR FOR KAWASAKI KAF620M MULE 4010 4x4 08-10 •Designed for industrial or other applications where a lower-than-stock speed limiter is required •Allows full power to be used up to the programmed speed limit •Uses factory connectors •Easy to install with no modifications to the factory harness DESCRIPTION PART # Shift rod linear sensor (push type, includes mounting kit) 1601-0014 DESCRIPTION PART # Shift rod linear sensor (push type, includes mounting kit) for Power Commander V 1601-0247 DYNOJET QUICK SHIFTER (DQS) SENSORS USB/V •Races are won or lost in fractions of a second • Dynojet’s Quick Shifter (DQS) kit allows full-throttle, clutchless upshifts in racing and performance riding applications •The shift rod pressure/tension sensor kit is a universal sensor that mounts to the shift rod in a push configuration •Requires modification of gear-linkage tie-rod •The linear travel sensor kit works with bikes that have no shift rod, or on those the shift rod sensor will not fit •Mount one end to the shift lever and the other to a fixed point on the chassis •Push type available with universal mounting kit •Plugs directly into the Power Commander expansion port with no re-wiring required •Power Commander Control Center software lets you set engine dead time during upshifts and minimum rpm for system operation • PART #1601-0014 is a “linear” sensor for PCIII USB • PART #1601-0247 is a “linear” sensor for PCV NOTE: To order either of the above sensors, you must find the correct direction of movement during an upshift (push or pull). For the shift rod/pressure/tension sensor, press on the shift lever in the direction of an upshift to see if the rod is pushing or pulling on the clevis on the shift shaft. For the linear travel sensor, also move the shifter for an upshift. If movement is down, a pull sensor is needed. If movement is up, a push sensor is required. 1601-0014
RkJQdWJsaXNoZXIy OTcxOTk3