dragspecialties.com SECTION 7 All part numbers in BLUE are new for 2025. WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES 793 See OLDBOOK For Early Model Applications DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 5-7 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. PART # DESCRIPTION DS-199523 For 99-04 Twin Cam VALVE SPRING KIT •Incorporates an interference double-spring design with a damper to control harmonics •Engineered for maximum performance in severe applications such as high compression and big-inch street motors •0.600” spring kit is 1.460” OD and has a pressure of 160 lb. when closed and 440 lb. at 0.500” lift; installed height should be 1.850”; coil bind occurs at 1.200” •Kit includes locks, retainers and spring seats •Made in the U.S.A. PART # DESCRIPTION DS-199547 For 99-04 Twin Cam VALVE SPRING SET •Incorporate an interference double-spring design with a damper to control harmonics •Engineered for maximum performance in severe applications such as high compression and big-inch street motors •Spring set is 1.460” OD and has a pressure of 125 lb. when closed and 275 lb. at 0.500” lift; installed height should be 1.800”; coil bind occurs at 1.150” •Sold in a set of four springs (enough for one engine) •Made in the U.S.A. PART # DESCRIPTION DS-199739 For 99-04 Twin Cam and 86-03 XL Evolution HIGH-LIFT VALVE SPRING KIT •Accommodates cam lifts of 0.550”+ •Installation does not require machining of heads •Kit includes four inner and four outer springs •For use with titanium upper spring collars •Collars sold separately •Made in the U.S.A. PART # DESCRIPTION FOR 17-24 M-EIGHT 0926-3434 -0.050” installed height 0926-3435 +0.050” installed height PART # DESCRIPTION FOR 99-04 TWIN CAM, 86-03 XL, 95-02 BUELL 0926-2265 Screamin Eagle performance BeeHive® valve-springs with 0.725” top ID TITANIUM VALVE SPRING RETAINER KITS •PART #0926-3434 decreases installed valve spring height to help reduce the amount of shims needed to properly setup valve springs for cam lift (fits stock M-Eight valve springs and PART #0926-2973) •PART #0926-3435 increases valve spring installed height without the need for removing/cutting valve spring seat pockets/depths (fits M-Eight OEM, SE valve springs and PART #s 0926-2973 and 0926-3138) •PART #0926-2265 allows installation of the Screamin Eagle performance BeeHive® valve springs with 0.725” top ID onto the early style 5/16” valve stem cylinder heads and includes retainers, standard height steel keepers, machined steel spring seats and Viton® valve seals for factory guides •Made in the U.S.A. 0926-3434 0926-2265
RkJQdWJsaXNoZXIy OTcxOTk3