dragspecialties.com SECTION 6 All part numbers in BLUE are new for 2025. WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES 647 See OLDBOOK For Early Model Applications DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 5-7 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. THUNDERMAX ECMs WITH INTEGRAL AUTO TUNE SYSTEM •ThunderMax ECM with Auto-Tune module mounts conveniently in place of the factory ECM and plugs in to the existing harness •Utilizes wide-band O2 sensors and works as a closed-loop control system to continuously self-adjust and properly tune the motorcycle’s air/fuel ratio for all riding conditions •Easy installation: replace the factory ECM, install new O2 sensors and harness, load the correct map for your bike, and ride •Includes ThunderMax ECM with Auto-Tune Module, plug-in harness and two wide-band sensors, TMax software and communication USB cable, Quick-Start Easy Install and Comprehensive User’s Manual, technical support and free software and updates •Hundreds of maps available to download for your bike (based on model, engine size, exhaust system air cleaner, pistons, cams, etc.) – load the map of your choice and the integral auto-tune will do the rest •Improves throttle response, exhaust sound and driveability •Does not require dyno tuning •Rider can adjust idle speed, rev limit and speedometer calibration •Adjustable front and rear cylinder AFR maps, ignition timing (spark) maps, and startup maps THUNDERMAX PIGTAIL HARNESS •Allows a second port for the communication cable connection to the ThunderMax •Installed to the bike’s wiring harness at the 36-pin ECM connector (connection requires harness plug disassembly; two terminated wires are inserted into two unused ports in the 36-pin connector, and a ground wire added) •Handy for motorcycle models with tight clearances around the ECM such as Dyna, Softail Rocker and 02-05 V-Rod •Made in the U.S.A. PART # DESCRIPTION EMIS* ECM 1020-42443 For 24 FLHX/FLTRX/FLTRXSTSE 3 1020-3514 For 24 FLHTK/FLTRK/FLHRXS, 21-23 FLHT/FLHX/FLHR/FLTR, 21-24 FLHTCUTG/FLRT/FLTRT (except 23-24 FLHXSE/FLTRXSE) 3 1020-26642 For 17-20 FLHT/FLHR/FLHX/FLTR/FLTRX/FLTRU/FLTRK, 17-20 H-D Trike 3 1020-21181 For 14-16 FLHT/FLHR/FLHX/FLTR, 14-16 H-D Trike 3 1020-08361 For 08-13 FLHT/FLHR/FLHX/FLTR, 09-13 H-D FL Trike 3 1020-3515 For 21-24 Softail 3 1020-27952 For 18-20 Softail 3 1020-28501 For 16-17 FXS/FXST/FLS/FLST, 14-15 FXSBSE/FLSTNSE, 16-17 FXDLS 3 1020-23601 For 12-15 FXS/FLS/FLST, 12-17 FXD/FLD/FXDWG (except FXDLS), 14-20 XL 3 1020-1848 For 11 FXS/FLST 3 1020-1851 For 01-10 FXST/FLST, 02-07 FLHT/FLHR/FLTR/FLHX, 07-09 XL 3 1020-2361 For 08-10 FXCW/C, 04-11 FXD/FXDWG, 09 SE Softail, 10-13 XL, 08-12 XR1200/X (includes mini USB pigtail) 3 1020-18531 For 02-17 V-Rod 3 REPLACEMENT PART 1022-0039 Repl. 18 mm oxygen sensor (ea.) N/A 1 Will require the use of an exhaust system with 18 mm sensor bungs or headpipes must be modified to accept 18 mm sensors. 2 Not interchangeable or upgradeable from PART #1020-2118. 3 Does not support VVT. PART # DESCRIPTION 1022-0059 ThunderMax pigtail harness for V-Rod PART #1020-1853, Gen II PART #s 1020-0323, 1020-1279, 1020-1311 and AutoTune repl. module PART #1020-0322 1020-1855 ThunderMax Mini USB pigtail for remote access to modules PART #s 1020-1851, 1020-1852 and 1020-2361 NOTE: PART #1022-0059 requires ThunderMax ECM with serial number 114000 or higher (produced beginning August 2008). Will not work on previous model ThunderMax PART #232661 TBW unit. NOTE: PART #1020-1855 requires ThunderMax ECM with Mini USB communication port (beginning November 2012). Will not work on previous model ThunderMax ECM or PART #1020-0836 (Touring TBW units). •Works with all popular exhaust systems and is compatible with high-performance camshafts •Supports turbo, nitrous and supercharger applications •Software program allows live monitoring, recording and examination of diagnostic codes and datalogs including number of starts, engine temperature and rpm operation •New maps, software, firmware updates, map analysis and tech support available online at no charge •Made in the U.S.A. NOTE: Because of possible clearance issues, some aftermarket exhaust systems may require modifications or relocation of their O2 sensor port bungs. 1020-4244 1020-1851 1022-0039 1022-0059 1020-1855
RkJQdWJsaXNoZXIy OTcxOTk3