dragspecialties.com SECTION 10 All part numbers in BLUE are new for 2025. WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES 1099 See OLDBOOK For Early Model Applications DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 5-7 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. PART # DESCRIPTION 2120-1018 For 99-03 XL SPORTSTER COMPLETE BIKE HARNESS •Harness comes pre-installed with all OEM connectors •Fuse block holds 3 ATO fuses and a full size starter relay •Includes a 30-amp circuit breaker •Plug-and-play installation •Made in the U.S.A. PART # DESCRIPTION 2120-0769 Complete harness 2120-0973 Harness w/o turn signal wiring COMPLETE BIKE HARNESS •The perfect start for any project bike or OEM model re-wire •2120-0769 has provisions for front and rear turn signals which function as run, brake, turn signal •2120-0973 has no turn signal wiring, only indicator wiring •Complete bike harness with starter relay, 3-circuits, self-canceling and run, brake and turn signal module •Works with any stand alone, Evo or Twin Cam ignition system •Designed to operate with a two-position key switch •Key start switches can be used with a simple wiring modification (ignition system and key switch are not included with this harness) •OEM color-matching harness with 11-second self-canceling turn signal module •Fuse block holds a full-size, commonly available and replaceable starter relay and three (3) ATO fuses •A 30-Amp circuit breaker is installed and is ready for any regulator/charging system •Harness provides running light and turn signal functions to the front turn signals, run, brake and turn signal functions for the rear turn signals PART # DESCRIPTION 2120-0675 “D” model electronic controller w/ ribbon cable for indicator lights ELECTRONIC HARNESS CONTROLLER •Compact design makes it easy to hide on a custom motorcycle •Performs all fuse, relay and signal-canceling functions in one simple package •Allows a dual-filament bulb to be used in three ways: tail, brake and turn signal (excluding the need for a center brake light); includes ribbon cable for integrating generic indicator lights •Weather-resistant connections for trouble-free use in extreme environments •Trim-to-fit harnesses allow installation on most custom bikes •Oil, neutral, high beam and turn signal indicator wiring •Color-matching handlebar switch wiring, as found on most 96-13 models (except Dresser models) •Headlight wiring with headlight socket and terminals •Front turn signal connectors and terminals •Rear fender harness with connectors and terminals •Key switch wiring with ring terminals •Coil wire with ring terminals, tachometer, horn, oil sending unit, brake switch and neutral switch wiring with terminals •Sections of 3/16”, 1/4”, 3/8” and 1/2” ID heat shrink included •Heavy-gauge, 12 (+) power and (-) ground wires with terminals for battery connection •Made in the U.S.A. 2120-0973 2120-0769
RkJQdWJsaXNoZXIy OTcxOTk3