dragspecialties.com All part numbers in BLUE are new for 2025. SECTION 10 WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES 1088 See OLDBOOK For Early Model Applications DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 5-7 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. REPLACEMENT TWIST GRIP SENSORS •Pre-installed terminals that utilize MIL-SPEC crimping presses •Hardwired, like OEM CVO versions, from the sensor to the main connection on the harness •Plug-and-play installation •PART #2130-0347, sensor includes OEM #72188-07BK male 6-position connector for installation after the harness is routed through the handlebar •PART #2130-0348, sensor includes OEM #72414-07BK female 6-position connector for installation after the harness is routed through the handlebar •PART #2130-0349, sensor includes installed OEM #69201162 micro-connector for easy installation after routed through the handlebar •Additionally includes an installed male 2-position heated grip connection OEM #72902-01BK, which is NOT installed to place wiring harness through handlebar •Made in the U.S.A. NOTE: Make sure grip is snug against gear drive to prevent damage. PART # DESCRIPTION 2130-0349 For all 16-24 H-D Throttle-By-Wire models (except 23-24 FLHXSE/FLTRXSE, 24 FLHX/FLTRX/FLTRXSTSE) PART # DESCRIPTION 2130-0348 For all 14-15 H-D Throttle-By-Wire models 2130-0347 For all 08-13 H-D Throttle-By-Wire models THROTTLE-BY-WIRE AND HEATED GRIP WIRE EXTENSION KIT •Will work with up to 20” bars •Includes all required wires to extend both the Throttle-By-Wire harness as well as the heated grip harnesses NOTE: 11-15 CVO Softail models do not come with heated grips from the factory; this kit may be used as a TBW extension only on those models. HEATED GRIP EXTENSIONS •Will work with up to 20” bars •Include all necessary wires to extend heated grips for taller bars THROTTLE-BY-WIRE EXTENSION HARNESSES •Plug-and-play extension for Throttle-by-wire (TBW) harness when installing taller handlebars •JST connectors easily route through most handlebars •Eliminates wire splicing and modification •Comes in 4” or 8” lengths •Sold each THROTTLE-BY-WIRE EXTENSION KITS •Wiring extension kits for electronic throttle control •Feature OEM-match color-coded wires with factory connectors •Work for most handlebar heights (up to 20” Ape Hangers) •Made in the U.S.A. THROTTLE-BY-WIRE EXTENSION KITS •Wires of pre-cut lengths are prepped to easily extend OEM wires when installing extended handlebars •Color-matched wires include Molex terminals on each end PART # DESCRIPTION 2120-0947 For 08-13, 11-15 FLHTCUSE/FLHXSE/FLTRSE/FLHRSE PART # DESCRIPTION 2120-0946 For 10-23 FLHTK, 14-22 FLHTKSE/FLHXSE/FLTRUSE/FLHRSE/FLTRXSE PART # DESCRIPTION FOR 16-24 FLHR/FLHTCU/FLHX/FLTR, 16-24 H-D TRIKE, 16-24 SOFTAIL W/ TBW 2120-1358 4” 2120-1359 8” PART # DESCRIPTION 2120-0840 For 16-22 TBW models 2120-0641 For 14-15 TBW models PART # DESCRIPTION 2120-0544 For 08-13 TBW models PART # DESCRIPTION FOR 08-13 FLHT/FLTR/FLHX/FLHR/H-D FL TRIKE 2120-1177 4” extension kit 2120-1173 8” extension kit 2120-1172 12” extension kit 2120-1171 15” extension kit 2130-0349 2130-0348 2130-0347 2120-0641 2120-1177 2120-1358
RkJQdWJsaXNoZXIy OTcxOTk3