BOLD MAGENTA part numbers are new for 2025 DRAGSPECIALTIES.COM 2025 | TIRE & SERVICE V-TWIN TOOLS 666 PART # DESCRIPTION 3850-0685 For 84-24 H-D cylinder heads and S&S cylinder heads EXHAUST GASKET INSTALLATION TOOL •Installs exhaust gaskets evenly in the cylinder head damage- and leak-free • Works with Evolution,Twin Cam, M-Eight, XL and S&S cylinder heads •Tool is two-sided; one side for tapered gaskets, one side for straight gaskets •Works with a 3/8” drive socket extension for smooth, efficient installation •Impact-resistant nylon construction •Made in the U.S.A. PART # DESCRIPTION DS196277 For Twin Cam, 0.927” wrist pin DS-196094 For Evolution, 0.791” wrist pin ROD ALIGNMENT TOOLS •Use to check rod straightness without removing the rods from the cases • Alignment tool is 4.5” long • Available in Twin Cam and Evolution applications •Made in the U.S.A. PART # DESCRIPTION DS-196159 For 36-99 Big Twin, 57-20 XL and Buell (except 1125R) PISTON PIN BUSHING TOOL •Use to remove and install wrist pin bushings without removing rods from crankcase •Made in the U.S.A. PART # DESCRIPTION 3801-0045 For Evolution Big Twin and XL EVOLUTION CYLINDER STUD ASSEMBLY TOOL •Assembly tool features a captive hardened ball bearing dimensionally set 1” from top of tool •Made of high-tensile steel • Works on all Evolution Big Twin and XL models •Made in the U.S.A. PART # DESCRIPTION 3850-0121 For 84-17 Big Twin (except M-Eight) and 86-22 XL EXHAUST GASKET SEAL INSTALLER TOOL •Installs fragile exhaust seal with ease and will position seal evenly to exhaust port of head •Can be used with exhaust flange nuts or JIMS handle PART #DS-196042; sold separately •Made in the U.S.A. PART # DESCRIPTION 3850-0227 Exhaust ring retainer tool EXHAUST RING RETAINER TOOL •Quickly and easily installs the exhaust pipe retaining ring on almost all H-D exhaust systems •Install the H-D #65325-83A ring in seconds, without scratching the exhaust pipe or twisting the ring •Made in the U.S.A. PART # DESCRIPTION 3801-0199 For Evolution Big Twin, Sportster and Twin Cam w/ 3/8” stud CYLINDER SLEEVE HOLD-DOWNS •Specialty nuts are used to hold down cylinder sleeves during service •Allow motor to be turned over with heads off •Nuts fit 3/8”-16 UNC thread •Feature 3/4” hexagon with a small cylinder protruding down to catch the cylinder stud •Case-hardened and zinc-plated •Sold in 4-pack PART # DESCRIPTION 3850-0161 For 99-17 Dyna EXHAUST BRACKET WRENCH •To remove and install the front exhaust bracket •93/4” L; single end with reversible ratcheting action • Removable/replaceable shortened T-27 Torx bit •Low-profile design allows for easy access to the exhaust bracket in between the frame and engine •Vinyl grip protects bike from damage during use and provides an ergonomic grip PART # DESCRIPTION DS-197032 For 84-17 Big Twin (except M-Eight), 86-22 XL and 94-09 Buell (except 1125R) EXHAUST STUD DRILL PLATE •Designed to drill broken exhaust studs •Can be used with most motors still in the frame •Includes drill bushing and 1/4” drill bit •Made in the U.S.A. DS-196094 DS196277
RkJQdWJsaXNoZXIy OTcxOTk3