BOLD MAGENTA part numbers are new for 2025 DRAGSPECIALTIES.COM 2025 | TIRE & SERVICE V-TWIN TOOLS 662 PART # DESCRIPTION FOR 99-17 TWIN CAM 3801-0160 Installer tool PART # DESCRIPTION FOR 99-17 TWIN CAM (CONT) 3801-0161 Repl. drive for PART #3801-0160 CAM BEARING INSTALLATION TOOL •Used to install the two inner cam bearings •Designed to press from the letter side of the inner cam bearing to eliminate any damage to the bearings, cam or case • Will set bearings 0.023” to 0.028” below case surface •Made in the U.S.A. PART # DESCRIPTION DS-196196 For 99-06 Twin Cam (except 06 Dyna) CAM CHAIN TENSIONER TOOL •Designed to unload the pressure on the primary and secondary chain tensioners •Also checks spring loads on chain tensioners •Includes instructions •Made in the U.S.A. PART # DESCRIPTION 3801-0310 For M-Eight,Twin Cam and Evolution lifter bores LIFTER BORE MEASURING KIT •A set of precision-ground steel balls to accurately measure lifter bore diameter and bore roundness •Feuling recommends a lifter to lifter bore clearance of 0.001” to 0.0015” for optimum lifter performance • Includes sizes 0.8430”, 0.8435”, 0.8440”, 0.8445” and 0.8450” •Made in the U.S.A. PART # DESCRIPTION DS196315 For 70-99 Big Twin and aftermarket cases (except Twin Cam) CAM BEARING AND BUSHING ALIGNMENT TOOL •Use to check the alignment of cam bearing to cam cover bushing to within 0.0003” of centerline •Binding of tool indicates misalignment of cam cover and bushing •Made in the U.S.A. PART # DESCRIPTION DS-197036 For 70-99 Big Twin (except Twin Cam) BIG TWIN CAM SEAL INSTALLER/REMOVER •Installs and removes cam seals without removing the cam cover •Used to remove cam cover from the case •Made in the U.S.A. 3801-0160 3801-0161 PART # DESCRIPTION DS-197047 For 58-99 Big Twin (except Twin Cam) INNER CAM BEARING INSTALLATION TOOL •Easily presses the inner cam bearing smoothly into the right case with the cases assembled to the proper depth •Made in the U.S.A. PART # DESCRIPTION DS-196114 For 70-99 Big Twin (except Twin Cam) CAM BUSHING LINE REAMING TOOL • Finished size will be 0.0008” to 0.0015” over the cam journal •Made in the U.S.A.
RkJQdWJsaXNoZXIy OTcxOTk3