BOLD MAGENTA part numbers are new for 2025 V-TWIN TOOLS DRAGSPECIALTIES.COM TIRE & SERVICE | 2025 655 PART # DESCRIPTION 3801-0259 For 99-17 Twin Cam ROCKER BOX ALIGNMENT SCREWS • Prevents misalignment of cover, compromising of seal and potential rocker interference •Sold in pairs •Made in the U.S.A. PART # DESCRIPTION DS-197077 For L76-17 Big Twin (except M-Eight) TAPPET BLOCK/OIL PUMP TO CAM PLATE ALIGNMENT TOOL •Used to align oil hole from crankcase to tappet block •Can also be used to align rocker box bases on Evolution head (requires two tools) • Aligns Twin Cam oil pump to cam support plate; two required •Sold each •Made in the U.S.A. PART # DESCRIPTION 3801-0002 Tappet screen plug tool TAPPET SCREEN PLUG TOOL • For use on 70-99 Big Twin (except Twin Cam) with slotted screw tappet oil filter screen cover •Designed for use with 7/16” combination wrench to allow for maximum rotation without touching engine cases •O-ring design retains the tool in wrench or socket •Flange design allows downward force to be applied to tool •Can be used without removing exhaust pipes on most bikes •Tappets should be serviced every oil change PART # DESCRIPTION DS-198638 For 70-99 Big Twin TAPPET OIL SCREEN PLUG TOOL •Used to remove the tappet oil screen plug •Removes oil screen without removing exhaust •Made in the U.S.A. PART # DESCRIPTION 3801-0275 For all 99-17 Twin Cam and 00-20 XL and Buell (except 1125R) TAPPET POSITION HOLDING TOOL •Safely stores anti-rotation pins and tappets for proper and accurate installation •Locations of the tappets are marked on the tool; prevents damage after being removed from the engine •Made in the U.S.A. PART # DESCRIPTION 3801-0410 For all Twin Cam and M-Eight MAGNETIC TAPPET HOLDERS •Easily hold the tappets in the tappet bores when the cam is removed •Install the tool over the tappet cover and the rare earth magnets will hold the tappet in place while performing any cam chest work •Includes a form-fitted tray to protect magnets from damage when stored •Made in the U.S.A. PART # DESCRIPTION 3801-0261 For L76-17 Big Twin (except M-Eight) TAPPET BLOCK/OIL PUMP ALIGNMENT TOOL • Big Twin tappet blocks do not have counter-bored bolt holes; therefore, when a tappet block is removed (or even just loosened) it should be reinstalled using an alignment tool to ensure that the lifters track properly on the camshaft •This tool makes the process quick and easy, ensuring the durability of your installation • Tool also aligns Twin Cam oil pump to the cam support plate; two tools required •Sold each •Made in the U.S.A.
RkJQdWJsaXNoZXIy OTcxOTk3