dragspecialties.com All part numbers in BLUE are new for 2024. SECTION 7 WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES 818 See OLDBOOK For Early Model Applications DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 5-7 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. PART # DESCRIPTION SUG. RETAIL 0932-0268 For 17-23 M-Eight $369.95 CAM PLATE FOR M-EIGHT •Precision-machined from billet aluminum •Blue anodized finish •Passage plugs are removable for servicing •For use with OEM or S&S oil pumps •Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL 0932-0193 For 17-23 M-Eight $299.95 OE+ CAMPLATE FOR M-EIGHT •Feuling® OE+ stock replacement billet camplate is manufactured from 6061 aluminum, providing increased rigidity and machined to Feuling’s high tolerance standards •Direct bolt-in replacement and accept the factory OEM oil pump only •Blueprinted and matched oil passages to the engine case passages, kidney shapes are designed to maximize flow •Optimizes oil flow to and from the oil pump and in and out of the engine, aiding in reducing oil and engine temps •Tighter cam journal bore tolerance for improved cam fitment •Added cam journal oil groove for cold start up protection and increased cam journal lubrication •Added oil pressure feed holes to front and back of cam journal to prevent excessive thrusting wear •For gear or chain drive cams (block-off plate PART #0932-0036 required when using gear drive cams) •Made in the U.S.A. NOTE: Not for 2023 models with 121” VVT motors. PART # DESCRIPTION SUG. RETAIL 0932-0192 For 17-23 M-Eight $379.95 HIGH FLOW CAMPLATE FOR M-EIGHT •Increases engine oil flow and volume by enlarging the oil pump reservoirs and critical oil passages including the scavenging return holes from the pump to the camplate and into the engine case •Camplate matches the oil portholes on the camplate to the oil holes in the engine case to increase oil flow throughout the engine •Lowers engine temperatures by 15-25 degrees and oil running temperature by 15-25 degrees when matched with a Feuling HP+ or RS oil pump •7075 billet aluminum construction, which is 50% harder and stronger than the factory cast and Feuling® OE+ camplates •Increases the strength and hardness of the camplate, holding tighter tolerances under temperature and eliminating flexing and the need for bronze bushings •When matched with the Feuling® Race Series Oil Pump, rear wheel power gains of 2 horsepower and 2 ft./lb. of torque can be achieved •For gear or chain drive cams (block-off plate PART #0932-0036 required when using gear drive cams) •Made in the U.S.A. NOTE: For use ONLY with Feuling HP+ and Race Series M-Eight oil pumps.
RkJQdWJsaXNoZXIy OTcxOTk3