dragspecialties.com All part numbers in BLUE are new for 2024. SECTION 10 WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES 1060 See OLDBOOK For Early Model Applications DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 5-7 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. THROTTLE-BY-WIRE AND HEATED GRIP WIRE EXTENSION KIT •Will work with up to 20” bars •Includes all required wires to extend both the Throttle-By-Wire harness as well as the heated grip harnesses NOTE: 11-15 CVO Softail models do not come with heated grips from the factory; this kit may be used as a TBW extension only on those models. THROTTLE-BY-WIRE EXTENSION KITS •Wiring extension kits for electronic throttle control •Feature OEM-match color-coded wires with factory connectors •Work for most handlebar heights (up to 20” Ape Hangers) •Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL 2120-0947 For 08-13, 11-15 FLHTCUSE/FLHXSE/FLTRSE/FLHRSE $65.95 PART # DESCRIPTION SUG. RETAIL 2120-0840 For 16-22 TBW models $55.95 2120-0641 For 14-15 TBW models 47.95 2120-0544 For 08-13 TBW models 47.95 HEATED GRIP EXTENSIONS •Will work with up to 20” bars •Include all necessary wires to extend heated grips for taller bars ELECTRONIC THROTTLE CONTROL EXTENSIONS •Allow easy changes in handlebar height on models with electronic throttle control •Made with OEM-type connectors •Applications listed with double harness include heated grip extension THROTTLE-BY-WIRE EXTENSION KITS •Wires of pre-cut lengths are prepped to easily extend OEM wires when installing extended handlebars •Color-matched wires include Molex terminals on each end PART # DESCRIPTION SUG. RETAIL 2120-0946 For 10-23 FLHTK, 14-22 FLHTKSE/FLHXSE/ FLTRUSE/FLHRSE/FLTRXSE $25.95 PART # DESCRIPTION SUG. RETAIL FOR 08-15 TOURING MODELS W/ SINGLE HARNESS (EXCEPT CVO/SE MODELS) 2120-0251 8” extension $48.71 2120-0252 12” extension 51.31 2120-0253 15” extension 54.56 2120-0857 20” extension (bare bottom end for routing through sharp bends) 48.64 FOR 10-15 TOURING MODELS W/ DOUBLE HARNESS (EXCEPT CVO/SE MODELS) 2120-0858 8” extension 61.93 PART # DESCRIPTION SUG. RETAIL FOR 10-15 TOURING MODELS W/ DOUBLE HARNESS (EXCEPT CVO/SE MODELS) (CONT) 2120-0859 12” extension $64.74 2120-0860 15” extension 66.27 FOR 16-20 TOURING MODELS AND 16-20 SOFTAIL, 16-17 FXDLS MODELS W/ DOUBLE HARNESS 2120-0861 8” extension 70.97 2120-0862 12” extension 71.22 2120-0863 15” extension 74.72 PART # DESCRIPTION SUG. RETAIL FOR 08-13 FLHT/FLTR/FLHX/FLHR AND H-D FL TRIKE MODELS 2120-1177 4” extension kit $29.95 2120-1173 8” extension kit 29.95 2120-1172 12” extension kit 29.95 2120-1171 15” extension kit 29.95 •Sold each •Made in the U.S.A. 2120-0858 2120-0857 2120-0862 2120-0641 2120-1177 REPLACEMENT TWIST GRIP SENSORS •Pre-installed terminals that utilize MIL-SPEC crimping presses •Hardwired, like OEM CVO versions, from the sensor to the main connection on the harness •100% plug-n-play •PART #2130-0347, sensor includes OEM HD# 72188-07BK male 6-position connector for installation after the harness is routed through the handlebar •PART #2130-0348, sensor includes OEM # 72414-07BK female 6-position connector for installation after the harness is routed through the handlebar •PART #2130-0349, sensor includes installed OEM # 69201162 micro-connector for easy installation after routed through the handlebar PART # DESCRIPTION SUG. RETAIL 2130-0349 For all 16-23 H-D Throttle-By-Wire models $149.95 2130-0348 For all 14-15 H-D Throttle-By-Wire models 149.95 PART # DESCRIPTION SUG. RETAIL 2130-0347 For all 08-13 H-D Throttle-By-Wire models $149.95 •Additionally includes an installed male 2-position heated grip connection OEM #72902-01BK, which is NOT installed to place wiring harness through handlebar •Made in the U.S.A. NOTE: Make sure grip is snug against gear drive to prevent damage. 2130-0348 2130-0347 2130-0349
RkJQdWJsaXNoZXIy OTcxOTk3