BOLD MAGENTA part numbers are new for 2023 PARTS-UNLIMITED.COM 2023 | STREET 2023 NEW PRODUCTS NP83 PL CONTROL BOX CB2 • Compact control module allows you to turn off a position light while the turn signal is activated • Makes installing 2-in-1 lights easy • Built-in reverse polarity protection • Once installed the position light and turn signal circuits are separated • Compatible with all dual function Highsider signals • Measures .43”W x .68” L • Sold in pairs NOTE: Not compatible with headlights with position light. 27 OHM RESISTORS • Eliminate fast flashing when converting from incandescent turn signals to LED signals • These 27-ohm Shin Yo turn signal resistors provide the proper resistance and ensure a steady flash • Sold in pairs UNIVERSAL LOAD RESISTOR • Turn signal resistors are a key component when converting from incandescent to LED turn signals • Once installed, this resistor will eliminate any fast flashing caused by LED turn signals • 12-Watt, 15 Ohm • Sold each UNIVERSAL 3-PIN LED FLASHER RELAY • Eliminate fast flashing caused by incandescent to LED light conversions • This Shin Yo universal 3-pin flasher relay is complete with an adjustable flasher frequency • Universal for all 12V systems • Includes universal wiring harness • Sold each CBW1 CAN-BUS RESISTOR • Compatible with most vehicles equipped with a CAN-BUS system • Provides the required electrical load to the electrical system • When the DIP switches are set correctly, the CBW1 will eliminate an error message and fast flashing caused by aftermarket LED turn signals • Up to 2 channels can be operated (front and rear or left and right) • If all four turn signals are replaced, 2 x CBW1 are required • Requirements for use of the CBW1 on the vehicle: 1) LED indicators were factory installed on the vehicle, 2) The vehicle has a CAN-BUS system TURN SIGNAL WIRE ADAPTER • Direct OE style replacement turn signal adapter plug • Fits all KTMs and Husqvarnas • Eliminate the need to cut and splice wiring when using aftermarket turn signals or marker lights • Includes two turn signal wire adapters, with one 2-pin male connector and two female bullet connectors • Length: 6.30” TWO-CHANNEL ELECTRONIC RELAY • With two channels, this relay can control two independent circuits and provide unwanted damage to push buttons due to high current • Compatible with 6V to 14V systems with a max load of 40W • Converts pulsing ground turn signal inputs into positive signals, which is useful for Indian Motorcycles • Measures: .66" W x .37" D x .66" H • Sold each UNIVERSAL DIGITAL FLASHER RELAY, 2 WIRE • The Highsider BR10 Digital Flasher Relay is a compact, load-independent digital flasher unit • Ideal for LED flasher conversions or incandescent 10W to 21W turn signal bulbs • The BR10 is waterproof, vibration-proof, wear-free and overload-proof • Sold each PART # SUG. RETAIL 2050-0472 $19.99 PART # SUG. RETAIL 2050-0469 $7.99 PART # SUG. RETAIL 2050-0475 $19.99 PART # SUG. RETAIL 2050-0468 $29.99 PART # SUG. RETAIL 2020-2045 $16.95 PART # SUG. RETAIL 2050-0473 $29.99 PART # SUG. RETAIL 2050-0470 $34.99 PART # SUG. RETAIL 2050-0474 $9.99
RkJQdWJsaXNoZXIy OTcxOTk3