BOLD MAGENTA part numbers are new for 2023 FUEL/AIR SYSTEMS PARTS-UNLIMITED.COM STREET | 2023 1453 DISCLAIMER: NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES. SEE PAGES 4-5 FOR IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. DYNOJET QUICK SHIFTER (DQS) SENSORS USB/V continued on next page. PART # SUG. RETAIL 1020-2371 $315.54 POD-300 DIGITAL DISPLAY • Real time fuel adjustment • Display channels real time: rpm,TP,map position (when using map switch), duty cycle, fuel exchange, ignition change and wideband air/fuel ratio (w/ WB2 or auto-tune connected) • Weather resistant for use in all conditions • Log channels saved to internal memory and can be viewed/analyzed with Dynojet’s powercore software • High-contrast display, viewable in sunlight • Includes CAN cable for attachment to Power Commander V, Auto Tune and Wide Band Power Commander • Made in the U.S.A. NOTE: Not for use with Power Commander III USB. PART # SUG. RETAIL 1601-0423 $252.99 IGNITION QUICK SHIFTER • Allows any vehicle with up to four coils to have quick shifter functionality • Features the latest Intellishift™ technology and provides the smoothest shifts of any stand-alone unit on the market • Kill times per rpm band and shift sensor activation point are adjustable • Includes Denso coil cap connectors for easy installation on many late-model motorcycles; connectors can be removed for applications without this style of coil • Control box only; requires Power Commander shifter sensor • Made in the U.S.A. DYNOJET QUICK SHIFTER (DQS) SENSORS USB/V • Races are won or lost in fractions of a second • Dynojet’s Quick Shifter (DQS) kit allows full-throttle, clutchless upshifts in racing and performance riding applications • Shift rod pressure/tension sensor kit is a universal sensor that mounts to the shift rod in either a push or pull configuration; requires modification of gear-linkage tie rod • Linear travel sensor kit works with bikes that have no shift rod, or on those the shift rod sensor will not fit, by mounting one end to the shift lever and the other to a fixed point on the chassis; available in push or pull types with universal mounting hardware • Plugs directly into the Power Commander expansion port with no rewiring required • Power Commander Control Center software lets you set engine dead time during upshifts and minimum rpm for system operation • PART# 1601-0510 and 1601-0512 “pressure style” sensors for PCV/USB and have two terminals, so it can either act as “push” or “pull” type • PART #s 1601-0013 and 1601-0014 are “linear” sensors for PCIII USB • PART #1601-0247 is a “linear” sensor for PCV • Made in the U.S.A. NOTE: To order either of the above sensors, you must find the correct direction of movement during an upshift (push or pull). For the shift rod/pressure/ tension sensor, press on the shift lever in the direction of an upshift to see if the rod is pushing or pulling on the clevis on the shift shaft. For the linear travel sensor, also move the shifter for an upshift. If movement is down, a pull sensor is needed. If movement is up, a push sensor is required. 1601-0512 1601-0014 1601-0014
RkJQdWJsaXNoZXIy OTcxOTk3