BOLD MAGENTA part numbers are new for 2023 PARTS-UNLIMITED.COM 2023 | ATV/UTV AUDIO/COMMUNICATION & MOUNTS 128 PART # SUG. RETAIL 0603-0819 $35.95 RAM TOUGH-TUBE™ ROD HOLDER WITH BULKHEAD/FLAT SURFACE BASE • High-strength composite • Ratchet system allows for multiple articulation points • Lanyard tie points for extra security • Custom designed for heavy chop environments • Mounts virtually anywhere on heavy rigged kayaks without hinderance • Inner diameter 1.9” • Inner tube length 10” (from bottom to top of lip) • Post spline length 3” • Compatible with all RAM and third-party post spline bases • Compatible with spinning reels and level wind reels • Made in the U.S.A. PART # SUG. RETAIL 0603-0820 $61.95 RAM ROD® FISHING ROD DOUBLE BALL MOUNT • Unique design offers quick removal of the rod when a fish is caught • Features a securing flip-over bail for rod security • High-strength composite, powdercoated marine-grade aluminum • Two RAM C-size 1.5” rubber balls • Ideally suited for kayaks or traditional fishing vessels • Kit includes 1.5” ball with a 2.5” diameter mounting base • Made in the U.S.A. PART # SUG. RETAIL 0603-0827 $11.95 RAM TOUGH-TRACK™ TOP-LOADING COMPOSITE 3”TRACK • High-strength composite • Can be drilled to any flat surface • Designed to use with #10 screws for easy installation; hardware not included • Works with a wide variety of RAM track bases to attach cameras, fishing rods, phones, etc. • Track thickness .35”, inside track length 3” • 4.75” L x 1.75”W PART # SUG. RETAIL 0603-0828 $16.95 RAM TRACK BALL™ WITH T-BOLT ATTACHMENT • B-size, 1” rubber ball molded to a high-strength composite base • Rubber friction washer and a stainless steel T-bolt for sliding into virtually any track system • Insert or slide the Track Ball™ into your track and twist the ball clockwise to tighten in place; twist counterclockwise to loosen PART # SUG. RETAIL 0636-0142 $17.95 RAM MOTORCYCLE BRAKE/CLUTCH RESERVOIR BASE WITH 1” BALL • Powdercoated marine-grade aluminum • 1” rubber B-sized ball • Connects to handlebar clutch/ brake on left or right side • Base fits control clamps on motorcycle with 40mm x 6mm stainless steel hardware, provided in kit • Hole centers on base have a minimum width of 0.94” and a maximum of 1.58” PART # SUG. RETAIL 0636-0058 $29.95 RAM MOUNT MOTORCYCLE BRAKE/CLUTCH RESERVOIR BASE WITH 1” BALLS • Mounts electronic devices to your handlebar clutch/brake clamp • Holds two 1” diameter mounting balls • Ball that is connected between hole centers is removable • Includes 40mm x 6mm stainless steel hardware NOTE: To see if this base will mount to your motorcycle, check hole spacing of base against your clutch/brake reservoir. The hole centers have a minimum width of 0.94”and a maximum of 1.58”
RkJQdWJsaXNoZXIy OTcxOTk3