BOLD MAGENTA part numbers are new for 2023 PARTS-UNLIMITED.COM 2023 | ATV/UTV FUEL/AIR SYSTEMS 1048 DISCLAIMER: NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES. SEE PAGES 4-5 FOR IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. DESCRIPTION PART # SUG. RETAIL Shift rod linear sensor (push type, includes mounting kit) 1601-0014 $292.21 DESCRIPTION PART # SUG. RETAIL Shift rod linear sensor (push type, includes mounting kit) for Power Commander V 1601-0247 $356.66 DYNOJET QUICK SHIFTER (DQS) SENSORS USB/V • Races are won or lost in fractions of a second • Dynojet’s Quick Shifter (DQS) kit allows full-throttle, clutchless upshifts in racing and performance riding applications • The shift rod pressure/tension sensor kit is a universal sensor that mounts to the shift rod in a push configuration • Requires modification of gear-linkage tie-rod • The linear travel sensor kit works with bikes that have no shift rod, or on those the shift rod sensor will not fit • Mount one end to the shift lever and the other to a fixed point on the chassis • Push type available with universal mounting kit • Plugs directly into the Power Commander expansion port with no re-wiring required FITS MODEL PART # SUG. RETAIL HONDA TRX420 Rancher 07-12 1020-1994 $356.66 FITS MODEL PART # SUG. RETAIL KAWASAKI KAF620M Mule 4010 4x4 08-10 1020-1226 $356.66 SPEED GOVERNORS • Designed for industrial or other applications where a lower-than-stock speed limiter is required • Allows full power to be used up to the programmed speed limit • Uses factory connectors • Easy to install with no modifications to the factory harness • Power Commander Control Center software lets you set engine dead time during upshifts and minimum rpm for system operation • PART #1601-0014 is a “linear” sensor for PCIII USB • PART #1601-0247 is a “linear” sensor for PCV NOTE: To order either of the above sensors, you must find the correct direction of movement during an upshift (push or pull). For the shift rod/pressure/tension sensor, press on the shift lever in the direction of an upshift to see if the rod is pushing or pulling on the clevis on the shift shaft. For the linear travel sensor, also move the shifter for an upshift. If movement is down, a pull sensor is needed. If movement is up, a push sensor is required. 1601-0014 1601-0014 1020-1994
RkJQdWJsaXNoZXIy OTcxOTk3